Burnt-out lamp, don’t waste your money: the electrician’s technique to fix it in 1 minute (Page 2 ) | February 10, 2025

In this case, the defective part must be repaired. In short, the causes can be varied, but do you know how to repair a burnt-out light bulb in no time? We’ll tell you how electricians do it. Very little is enough: Let’s find out more.

The procedure for repairing a burnt-out light bulb: simple and quick.
To repair a burnt-out light bulb, you will need a small screwdriver, insulating tape, LED wire and needle-nose pliers. Before you start, remember to disconnect the bulb from the mains – this is the first step to working safely.

First remove the broken LED bulb from the lamp using the screwdriver. Be careful not to touch the glass of the bulb, otherwise you could burn yourself. Once you have removed the broken bulb, pull the filament out of the broken bulb using needle-nose pliers.

Next, you need to replace the LED string that you bought at your local hardware shop. Solder them together perfectly using adhesive tape. Finally, insert the light bulb into the lamp and switch it back on.

You can fix it in less than two minutes with just a few simple steps. Isn’t that incredible? Do-it-yourself remedies are always the best because they are not only cheap, but also very simple, practical and quick. However, if you don’t have the confidence to carry out this small operation, contact an electrician.

Next: Super natural antibiotic that destroys all bladder and kidney infections after first use!

READ IT!

Share Share Share

Thanks for your SHARES!