Stop buying another rose tree at the store. Grow one at home in a glass of water with these steps (Page 2 ) | May 30, 2025
Annonce:

3. Essential Materials Needed to Start

Advertisement:

To begin growing a rose tree in water, you will need a few basic materials: a healthy rose cutting, a clean glass container, and fresh water. It’s important to choose a glass container that is tall enough to support the cutting and allow room for root growth. A clear glass is preferable, as it allows you to monitor the development of the roots.
In addition to these primary materials, you may also need a pair of sharp pruning shears to take the cutting, and optionally, a rooting hormone to enhance root development. While not necessary, rooting hormone can increase the chances of successful propagation by providing additional auxins to the cutting.

4. Choosing the Right Rose Cutting

Selecting the right rose cutting is crucial for successful propagation. Look for a healthy, disease-free rose stem that is about 6 to 8 inches long and has at least three to four leaf nodes. The cutting should be taken from a mature rose bush, ideally from a stem that has recently bloomed and is beginning to fade.
It’s best to take the cutting in the morning when the plant is well-hydrated. Use sharp, clean pruning shears to make a diagonal cut just below a leaf node, as this is where new roots are most likely to form. Remove any flowers or buds from the cutting to direct the plant’s energy towards root development.

5. Preparing the Rose Cutting for Propagation

Advertisement:

Once you have your rose cutting, it’s important to prepare it properly for propagation. Start by removing the lower leaves, leaving only a few at the top to support photosynthesis. This reduces water loss and encourages the cutting to focus on root growth.
If you are using rooting hormone, dip the cut end of the stem into the powder or gel, tapping off any excess. This step is optional but can enhance the rooting process. After preparing the cutting, it’s ready to be placed in the glass container filled with water.

6. Setting Up Your Glass Container

Choose a clean glass container that is tall enough to support the cutting without submerging the leaves. Fill the container with fresh, room-temperature water, ensuring that the bottom two inches of the cutting are submerged. It’s important to use non-chlorinated water, as chlorine can inhibit root growth.
Place the container in a location that receives bright, indirect sunlight. Direct sunlight can cause the water to heat up and promote algae growth, which can be detrimental to the cutting. A windowsill with filtered light or a spot near a bright window is ideal.

see next page

Advertisement:

Page: 2 sur 3
SEE MORE..
Page: 2 sur 3 SEE MORE..

Thanks for your SHARES!

Advertisement: